Advertisement
START A CLEAN
RINSE CYCLE
To manually start a Clean Rinse cycle, press and hold the CLEAN button
for a few seconds, until "RECHARGE
NOW" flashes in the display. This
Clean Rinse cycle takes 3 minutes (unless the factory settings for back-
wash and fast rinse times have been changed, as shown below).
SET CLEAN
RINSE START TIME
By default the Central Water Whole Home Filtration System will Clean
Rinse at 1:00 a.m. The system will not filter water during the Clean Rinse
cycle. It is recommended that the Clean Rinse start time be set for when
water is not likely to be used in the household.
NOTE: If you also have a water softener, set the Central Water System's
Clean Rinse time for either one hour before or two hours after the
water softener's scheduled regeneration time.
To change the Clean Rinse start time:
1. Press the ENTER button a few times until "SET RECHARGE TIME" is
shown in the display.
2. Press the /X UP or V DOWN buttons to set the Clean Rinse time in 1
hour increments.
Be sure AM or PM is correct.
,
When the desired Clean Rinse time is displayed, press the ENTER
button a few times, until the time appears in the display, but is not
flashing.
RECHARGE
NOW
Figure 14
RECHARGE
TIME
I.Ft FI
I.ULI AM
Figure
15
SET LENGTH
OF CLEAN
RINSE
By default the Central Water Whole Home Filtration System's Clean
Rinse cycle will consist of a 2 minute backwash followed by a 1 minute
fast rinse. This should be sufficient for most applications.
Increasing the length of Clean Rinse time will increase the amount of
water flushed to drain during each Clean Rinse cycle. Increasing the
length of Clean Rinse should only be done in cases of very high amounts
of sediment, or other water issues.
To change the length of the backwash
or fast rinse parts of the Clean
Rinse cycle:
1. Press and hold the ENTER button for a few seconds, until the "000--"
screen appears, as shown at right.
2. Press the ENTER button once, so "SET TIME bA" appears in the dis-
play.
3. Press the /X UP or V DOWN buttons to set the length of backwash in
minutes.
4. Press the ENTER button when the desired backwash time is shown.
"SET TIME Fr" appears in the display.
3. Press the /X UP or V DOWN buttons to set the length of fast rinse in
minutes.
,
Press the ENTER button when the desired fast rinse time is shown.
The display will change to the time of day.
FIFI Fl ____
UUU
TIME
LO
1,211!
m
SET
TIME
FF-
I
Figure 16
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
14
Advertisement
