Advertisement
OPERATING
IN MANUAL
CLEAN
RINSE MODE
Clean Rinse cycles will run automatically, unless the automatic Clean Rinse
function has been disabled.
If this function has been disabled, it will be
necessary to manually initiate any Clean Rinse cycles.
It is recommended
that a Clean Rinse cycle should be run at least once each month, or more
frequently if necessary.
A manual Clean Rinse mode may be used when a drain (required for auto-
matic Clean Rinse) is not available.
However, it is recommended
that auto-
matic Clean Rinse be used if the drain requirements can be met.
IMPORTANT:
During the Clean Rinse cycle, whether manually or automati-
cally initiated, water will flow from the valve drain port at 3.4 gallons per
min. for 3 minutes.
If a permanent drain line has not been installed, provi-
sions must be made for the drain flow prior to initiating a Clean Rinse cycle
You must have empty containers ready that will hold at least 15 gallons of
water.
DISABLING AUTOMATIC CLEAN RINSE
To disable the automatic Clean Rinse function:
1. Press and immediately release the CLEAN button (pressing and holding
the button a few seconds would initiate a Clean Rinse cycle).
2. "RECHARGE OFF" will flash in the display, as shown in Figure 18, indi-
cating that the Central Water Whole Home Filtration System is in the
manual Clean Rinse mode (the automatic Clean Rinse function has been
disabled).
MANUALLY STARTING A CLEAN RINSE CYCLE
To manually start a Clean Rinse cycle:
1. If the drain line is not set up to discharge into a drain, you must have
empty containers ready that will hold at least 15 gallons of water.
2. Press and hold the CLEAN button for a few seconds, until "RECHARGE
NOW" flashes in the display, as shown in Figure 19.
3. When the Clean Rinse cycle is complete, the Central Water Whole Home
Filtration System will remain in the manual Clean Rinse mode.
RE-ENABLING
AUTOMATIC CLEAN RINSE
To return the Central Water Whole Home Filtration System to its automatic
Clean Rinse function:
1. Press and immediately release the CLEAN button.
2. The flashing "RECHARGE OFF" on the display should be replaced by the
normal time of day screen, as shown in Figure 20.
RECHARGE
Figure 18
RECHARGE
NOW
Figure 19
C.UC
I
111.13pM
Figure 20
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
16
Advertisement
