,_
WARNING:
Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficientto inflict
severe injury.
CHARGING
BA'n'ERY
PACK
See Figure t.
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it at least 3 to 6 hours prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged.
TO CHARGE
• Charge battery pack only with the charger and
charging stand provided.
•
Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only,
• Connect charger to power supply.
•
Place battery pack in charging stand. Align raised rib on
battery pack with groove in charging stand. See Figure
1.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
• When properly connected, the red light on charging
stand will turn on.
•
Note: Ifchargerdoes not chargebattery pack,retum battery
pack, charging stand, and chargerto yournearest Sears
RepairCenterfor electrical check.
• Afternormalusage,3 hours of chargingtimeisrequired tobe
fully charged.A minimum chargetimeof 3 to6 hoursis
required to recharge a completelydischarged tool.
• The battery pack will become slightlywarm to the touch
while charging.This is normal and does not indicate a
problem.
•
Do not place charger in an area of extreme heat or
cold. It will work best at temperatures between 50°F-
100°F.
• When batteries become fully charged, unplug charger
from power supply and remove the battery pack.
9