Table of Contents
Advertisement
Solving Picture Problems
You cannot turn on the projector.
Make sure the power cord is connected, then wait a moment for the P power light to
turn orange before pressing the
If you've set the
Key Lock
remote control to turn on the projector (see page 25).
If you've set the
Child Lock
on the projector for at least 3 seconds to turn it on (see page 25).
No picture appears on the screen or you see the message
Press the
Source
control to select the correct input source. Allow a few seconds for the projector to sync up
after pressing the button.
Press the
button on the remote control to make sure the picture hasn't been turned
Blank
off temporarily.
Check that the P power light is green, not flashing, and the lens cover is off.
The projector may be in standby (or sleep) mode. If the P power light is orange, press the
button to turn the projector back on.
Power
Make sure your video equipment is turned on.
Make sure your cable(s) are connected correctly (see page 15).
You're using a computer and no picture appears on the screen.
If you're using a PC:
Press the function key that lets you display on an external monitor. It's often labeled with
an icon such as
the
key while pressing it. Check your laptop's manual or online help.
Fn
On most systems, the
projector, or display on both at the same time. Allow a few seconds for the projector to
sync up after pressing it.
If the function key doesn't let you display simultaneously on both screens, you might
need to use the Display utility in the Control Panel to make sure that both the LCD
screen and external monitor port are enabled. From the Control Panel, open the
Power
, the control panel buttons are disabled; you must use the
, use the remote control or press and hold the
button on the projector or one of the
, but it may also be labeled
key lets you toggle between the LCD screen and the
button.
No Signal
Source
. You may have to hold down
CRT/LCD
button
Power
displayed.
buttons on the remote
Display
57
Advertisement
Table of Contents
