To Replace Headlight Bulb; Interlocks And Relays; To Replace Fuse/To Adjust Attachment Lift Spring; To Adjust Throttle Control Cable - Craftsman 917.273090 Owner's Manual

Keps
"erminal
._uard
(Red)
/, Cable
gative (Black)
Cable
°O REPLACE HEADLIGHT BULB
Raise hood
Pull bulb holder out of the hole in the
backside of the grill.
L Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill
L Close hood.
NTERLOCKS AND RELAYS
.oose or damaged wiring may cause your
ractor to run poorly, stop running, or
)revent it from starting.
Check wiring See electrical wiring
diagram in the Repair Parts section
I'O REPLACE FUSE
Replace with 30 amp automotive-type
)lug-in fuse The fuse holder is located
)ehind the dash.
rO ADJUST ATTACHMENT LIFT
_PRING
I, While holding spring bushing with
wrench, loosen jam nuL
, Turn adjustment bolt clockwise to
extend spring and reduce lift effort for
heavier attachments.
, Turn adjustment bolt counterclockwise
for lighter attachments
__ Retighten jam nut against spring
bushing.
MPORTANT: Do not adjust for maximum
_pring tension when using light attach-
-nents such as a mower. Adjust lift lever
_pring to aid in lifting attachmenL Do not
)verpower spring. When removing
_ttachment, always adjust spring tension
o its lowest position
Bushing
2 Unsnap headlight wire connector
3 Stand in front of tractor Grasp hood at
sides, tilt toward engine and lift off of
tractor
4. To replace, reverse above procedure
\ -
\
Headlight Wire
Connector
Hood
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish-
ment or individual Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary Check adjustment as de-
scribed below before loosening cable If
adjustment is necessary, proceed as
follows:
1 With engine not running, move throttle
control lever to fast position
2. Check that speed control lever is
against stop screw_ If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw
Tighten clamp screw securely.
Idle Fuel Adjusting Idle speed Adjusting
Needle Screw
Throttle
Control
Cable
Nut
Spring
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1 Raise hood
Lift
27
Choke
Control
_:::_"- Cable
Stol J
Scre_lam p