Craftsman 247.298770 Owner's Manual page 8

Thread ferrule [0) on other er_.d of gear
shift rod See figure 10
Secure ferrule in gear shift lever (as shown
in figure 11) with llair pin cotter (K),
FIGURE 8.
H. Thread hex jam nut (P) on one end of gear
shift rod, then thread gear shift rod into
ball joint on the top of pivot horn
assembly, 10 to 12 complete turns,
approximately 1,,t,inch. See figure 9,
FIGURE 9.
FIGURE 11.
K,,
L,,
To assemble the handle adjustment lever.
hook handle adjustment rod (already on
handle) into lever Hook to the outside
See figure 12
Place handle adjustment lever in place on
handle and secure with hex screw (F) and
tocknut (M) See figure 12 Do not over
tighten handle adjustment iever mt'sl
pivot freely.
FIGURE 10.
FIGURE 12.
M. Throttle Control Lever_
NOTE
The throttle control may have four
holes in the lever bracket, The holes
on the outside edge are to be used
for mounting on this unit° See figure
!3.
8