Table of Contents
Advertisement
•
Using an 6 mm key, loosen the socket head
screws securing the fence. See Figure 16, Adjust
the fence left or right until the framing square and
zero clearance throat plate are parallel.
•
Retighten the screws securely and recheck the
fence-to-table alignment.
6 mmSOCKET HEAD
SCREW(S)
6 mmSOCKET HEAD
SCREW(S)
Fig. 16
SQUARING
THE
SAW
BLADE
TO THE
FENCE
See Figures 17- 20.
•
Unplug your saw,
,_
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
Loosen the miter lock handle approximately
one-half turn.
Depress the miter lock plato and rotate the miter
table until the pointer on the control arm is
positioned at 0 °.
Release the miter lock plate and securely tighten
the miter lock handle.
Lay a framing square flat on the miter table. Place
one leg ofthe square against the fence. S_{dethe
other leg of the square against the flat part of saw
blade.
Note: Make sure that the square contacts the flat
part of the saw blade, not the blade teeth.
FENCE
FENCE
MITER
FRAMING
TABLE
SQUARE
VIEW OF BLADE
SQUARE WITH FENCE
LOCK PLATE
MITER
LOCKHANDLE
Fig. 17
BLADE
MITER FRAMING
TABLE SQUARE
VIEWOF BLADENOTSQUARE WITH
FENCE, A DJUSTMENTS A REREQUIRED
Fig. 18
BLADE
MITER
FRAMING
TABLE
SQUARE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
Fig. 19
16
Advertisement
Table of Contents
