WARNING!
Be careful when pressing the rail-release levers and sliding the component into or out of the rack. The
sliding rails could pinch your fingertips.
To extend a node from the rack:
1.
Pull down the quick release levers (1) on each side of the server.
2.
Extend the node on the rack rails until the node rail-release latches engage.
Figure 91 Extending the node from the rack
.
3.
After performing the replacement procedure, slide the node back into the rack:
a.
Press the node rail-release latches (1) and slide the node fully into the rack.
Figure 92 Sliding the node back into the rack
.
b.
Press the node firmly into the rack to secure it in place.
260
Component Replacement