Dram Configuration - Gigabyte GA-MA790FX-UD5P User Manual

DRAM Configuration

DCTs Mode (Note)
CPU Host Clock Control
x CPU Frequency (MHz)
Set Memory Clock
x Memory Clock
DDRII Timing Items
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x 1T/2T Command Timing
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc2 for DIMM2
x Trfc1 for DIMM3
x Trfc3 for DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
: Move
Enter: Select
F5: Previous Values
x RAS to RAS Delay
: Move
Enter: Select
F5: Previous Values
DCTs Mode
(Note)
Allows you to set memory control mode.
Ganged
Unganged
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
The settings under the four items above are synchronous to those under the same items in the
MB Intelligent Tweaker(M.I.T.).
DDRII Timing Items
Manual allows all DDR2 Timing items below to be configurable.
Options are: Auto (default), Manual.
(Note) This item is present only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
MB Intelligent Tweaker(M.I.T.)
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel.
[Unganged]
[Auto]
200
[Auto]
x2.66 533Mhz
[Auto] SPD Auto
Auto 7T 5T
Auto 7T 4T
Auto 7T 4T
Auto 20T 12T
Auto - - - -
Auto 5T 2T
Auto 90ns 90ns
Auto - - - -
Auto - - - -
Auto - - - -
Auto 10T 10T
Auto 3T 3T
Auto 11T 11T
F10: Save
Auto 4T
F10: Save
- 43 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
4T
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup