F_Panel Front Panel Header - Gigabyte GA-MA785GM-UD2H User Manual

Am2+/am2 socket motherboard for amd phenom ii processor/ amd phenom processor/ amd athlon ii processor/ amd athlon processor/ amd sempron processor
Table of Contents

Advertisement

10) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker and system status indicator on the chassis front panel
to this header according to the pin assignments below. Note the positive and negative pins before con-
necting the cables.
• MSG (Message/Power/Sleep LED, Yellow):
System Status LED
S0
S1
S3/S4/S5
• PW (Power Switch, Red):
Connects to the power switch on the chassis front panel. You may configure the way to turn off your
system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management Setup," for
more information).
• SPEAK (Speaker, Orange):
Connects to the speaker on the chassis front panel. The system reports system startup status by is-
suing a beep code. One single short beep will be heard if no problem is detected at system startup. If
a problem is detected, the BIOS may issue beeps in different patterns to indicate the problem. Refer
to Chapter 5, "Troubleshooting," for information about beep codes.
• HD (Hard Drive Activity LED, Blue)
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive
is reading or writing data.
• RES (Reset Switch, Green):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer
if the computer freezes and fails to perform a normal restart.
• NC (Purple):
No connection
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
Hardware Installation
Connects to the power status indicator on the chassis front panel. The LED
is on when the system is operating. The LED keeps blinking when the sys-
On
tem is in S1 sleep state. The LED is off when the system is in S3/S4 sleep
Blinking
Off
state or powered off (S5).
Message/Power/
Power
Sleep LED
Switch
2
1
Hard Drive
Reset
Activity LED
Switch
- 28 -
Speaker
20
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ga-ma785gm-us2hGa-ma785gpm-ud2h

Table of Contents