Installation Guide; Instructions For Unpacking - Haier HT18TS45SW User Manual

INSTALLATION GUIDE CONT.
LEVELING YOUR REFRIGERATOR
• Your refrigerator has two leveling legs that are located in the front bottom corners of your refrigerator.
After properly placing your refrigerator in its final position, you can level your refrigerator.
• Leveling legs can be adjusted by turning them counterclockwise to raise your refrigerator or by turning
them clockwise to lower your refrigerator. The refrigerator door will close easier when the leveling legs
are extended.
PROPER AIR CIRCULATION
• To ensure your refrigerator works at the maximum efficiency it was designed for, you should install it in
a location where there is proper air circulation, plumbing and electrical connections. Your refrigerator
is not designed to operate in temperatures below 55˚F (12˚C ) or above 95˚F (35˚C).
• Do not install your refrigerator in any location not properly insulated or heated, e.g. garage, etc.
Keep out of direct sunlight and away from heating sources such as radiators, heaters, and cooking
appliances.
• The following are recommended clearances around the refrigerator:
Sides...............1" (25 mm)

INSTRUCTIONS FOR UNPACKING

FRONT GRILLE
Your refrigerator comes with a front grille (toe kick), which is reversible based on which side of the
refrigerator the hinges are mounted on. To install the front grille, locate the non-hinge end using the
diagram below and follow the instructions below.
1. Snap the non-hinge side into the air flow opening on the lower rail of the refrigerator.
2. Then, snap the hinge side into the opposite air flow opening in the lower rail beside the bottom hinge.
Non-hinge side
LOWER
Top....................1" (25 mm)
Hinge side
PAGE 5 • SET UP & USE
RAISE
Back..................2" (50mm)
Non-hinge side
Hinge side