Features And Use - Haier HT18TS45SW User Manual

REVERSING THE DOOR CONT.
7. Replace top hinge cap and secure using original
screw.
Fig. 17
NOTE: Prior to re-installing handles, remove the
Haier logo badge from the face of the
©
door using a putty knife to gently pry it
from the door face. Any residue left on the
face of the door from the badge should be
removed by using Goo Gone

FEATURES AND USE

NOTE: All features not available on all models.
NOTE: If refrigerator has been placed in a
horizontal position for any period of time,
wait 4 hours after returning it to the upright
position before plugging it in.
TEMPERATURE CONTROL KNOBS
Your refrigerator will automatically maintain the
set temperature level. Turning the temperature
knob to the left will make both refrigerator and
freezer compartments warmer. Turning the knob
to the right will make both compartments colder.
You can turn the knob in either direction to adjust
the temperature to your needs. We recommend
setting the knob to the straight up and down
position and allowing it to run for at least 24 hours
before adjusting the temperature. Turning the
knob all the way left to the Off position will turn
off the refrigeration system, but does not remove
power to the refrigerator.
Be sure to follow the manufacturer's instructions
when using these products.
Do not use any abrasives or scouring pads to
remove the residue. Use a putty knife to pry out
7
the plug buttons covering the handle mounting
holes on the face of the door, being careful not to
scratch the door finish.
6
To re-install handles, please see the Door Handle
Installation section.
or WD-40 .
© ©
The freezer compartment also features a fan
tower knob, which is used to regulate air flow into
the compartment to fine tune the freezer. As with
the refrigerator temperature knob, we recommend
setting the knob to the straight up and down
position and allowing it to run for at least 24 hours
before adjusting it.
Refrigerator Temperature Knob
Freezer Fan Tower Knob
PAGE 12 • SET UP & USE