Chip Deflector - Craftsman 130.26620 Operator's Manual

l,'E_m
INSTALLING MOTOR IN BASES cont.
To install motor in plunge base:
1. Release the base clamp lever+
2. Une up the arrow on the base with arrow on
the motor+ (Fig. 8)
• To position switch on the right side of the
base, line up the base's arrow with arrow
on the motor housing that is below the
cord.
• To position switch on the left, line up the
base's arrow with arrow on the motor
housing that is below the switch.
3. Slide motor into base until resistance in felt.
(The base's guide pin is now engaged into
slot on motor.)
4. Turn the motor clockwise until it stops.
5. Push the motor into the base
as far as it wil! go.
6. Fasten the base clamp lever.
ALIGNMENT
BASE
Plunge Base
COARSE
ADJUSTMENT
NOTCHES
__J
CHIP DEFLECTOR
Intended as a safety guard.
The chip deflectors help keep dust and chips
out of your face; it will not stop objects larger
than chips thrown from the bit.
To remove chip deflector shield from fixed base,
press inward on tabs O Fig. 9, until it releases
from base and remove. To instaJIfollow same
directions, and snap back in position, The plunge
base chip deflector shield O Fig. 10, can be
flipped down and back up.
rmm
Fixed Base
ld[I ill]
-11- Plunge Base