Epson Stylus Pro 9000 Printer Manual page 45

2-6 | Monitoring and Configuring the Printer
Error messages (continued)
Message
LOAD ROLL PAPER
LOAD SHEET
PAPER
MAINTENANCE
REQ. <error
number>
NO INK CARTRIDGE Ink Out light(s)
OPTION I/F ERROR
PAPER JAM
PAPER NOT CUT
PAPER NOT
STRAIGHT
PAPER OUT
PUSH LEVER
DOWN
Light Explanation
Paper Out Paper source setting in print
light on options is different from
control panel.
A printer part will need to be
replaced soon.
Ink cartridge(s) not installed.
on
Wrong interface card installed. Turn off the printer and remove the
Paper Out Paper has jammed in the
light flashing printer.
Paper Out Roll paper was not cut
light flashing completely.
Cut paper did not fall off.
Paper Out Paper slipped and fed into the
light flashing printer at an angle.
Paper Out No paper is loaded.
light on
Paper ran out.
Paper Out Paper set lever was released
light on during the printing process or
another operation.
Response
Make sure the right paper is loaded
and the paper source setting is the
same on the control panel and print
options.
Note the error number and contact
EPSON as described in the
Introduction.
Install ink cartridges as indicated by
the lights. See 3-6 for instructions.
card. See A-2 for instructions.
Remove the jammed paper. See 4-11
for more information.
Cut the paper manually, then remove
the cut paper from the printer. Reload
paper, as described on 1-9.
Remove the cut paper from the
printer. Reload paper.
Reload paper, making sure the edges
are straight and aligned with both
rows of holes.
Load paper.
Remove any printouts or paper
remaining in the printer and load more
paper.
If the message appears during a print
job, reset the printer by pressing the
Pause button for 3 seconds. Then
load paper and resend the job.
Push the paper set lever down. Start
printing again from the beginning for
best results.
2-6