Advertisement
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown A.
Attach front shield tabs(with holes) under front brace with two #8x3/8" self-tapping screws, shown B.
#8x3/8"self-tappingscrew
Qty.2
front tab
rear tab
(w/hole)
Note:some parts omitted
for clarity ofillustration
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections, shown A.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
Total (2) connections, shown A.
NOTE: Switchterminals
are larger than electrode terminals and should only be installed in location shown as (a),(b).
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown B.
Insert AA battery into ignition module, negative (=) end first. Then put on the cap, shown C.
464223610.19
Advertisement
