Troubleshooung -General - Char-Broil Gas Grill Use & Care Manual

Problem
Burner will not light
using ignitor.
Troubleshooting - General
Possible Cause
Wire(s) and/or electrode
covered with cooking residue
Electrode(s) and burner are
wet
Electrode(s) crackedor broken
"sparks atcrack"
Wire(s) isloose or
disconnected
Wireis shorting (sparking)
Burner(s) will not
match light°
Sudden drop in gas
flow or low flame,
PreventiontCure
Cleanwire(s) and/or electrode with
rubbing alcohol and dean swab.
Wipe drywith clofl_
Replaceelectrode(s)
between ignitor andelectrode
Bad ignitor
No gas flow
Reconnect wires or replace
eleclrodelwire assembly
Replace ignitorwire/electrode
28
Coupling nutand
regulatornotfully connected
Obsiructionof gasflow
Disengagemen!ofburner to
valve
Isgril! assembledcorrectly?
Outofgas.
Excess flow vaive lripped
assembly,
Replaceignitor
Check tosee if LP tank isempty. If
LP tank is nol empty, refer to
"Suddendrop in gas flow"
Turn the coupiing nut aboutone-
halfto threequarters additional
turn until solidstop Tighten by I_and
only-do notuse toois
Clear burner tubes
Reengage burner and valve
Reatlachspringclip (iffealured)
Checkstepsin assembfy
inslructions
Check for gas in LP tank
Turn off knobs,wait 30 seconds
and lighi grill
Ifflames are stilltowturn offknobs
and LPtankvalve Disconnecl
regulator Reconnectregulator and
leak check Turn on LP tank valve,
wait 30 seconds and thenlight grill