Char-Broil Gas Grill Use & Care Manual page 31

1
Possible Cause 1Cileck
l
I Procedure
Outputfead Are output
connectionsnot cormecfionson and
complete [igii?
Incompleteground Is ground ring
conneciion terminal Iooseon
mountingscrew?
(Iffealured)
Problem
Sparks are
3resent but not
at all electrodes
andlor not at full
strength.
Arcing to grill away
from burner(s)
Weak baltery
Electrodesare wet
Electrodescrackedor
broken "sparks a!
crack"
If possible,observe
gri/till darklocation
Operateignition
system and Iookfor
arcingbekveenoutpul
wires and grill frame
Ail sparks presentbut
weak or a( slow
rate
Has rnoisture
accumlJlated on
electrode andlor in
burnerporls?
lnspec[efeclrodesfor
cracks
Solution
Remove and reconnectall
outputconneclionsatmodule
and electrodes
Tighten mounling screwwith
ground ring securely Io leg
assembly
If sparks are observed olher
lhan from burner(s), wire
insulationmay be damaged
Replacewires
Replace batlery with a new
9-voll all<aline batlery.
Use paper loweI toremove
moisture
Replace cracked or broken
electrodes
Storing Your Grill
, Clean cooking grate(s) and discard old briquets or lava rock.
• Store in dry iocation
• When LP tank is connected to grill, store outdoors in well-ventilated space and out
of reach of children.
• Cover grill if stored outdoors Choose from a variety of grill covers offered by Char-
Broil
, Store grill indoors ONLY if LP tank is turned off and disconnected, removed from
grill and stored outdoors
, When removing grill from storage follow Cleaning Bulner Assembly instructions
before starting grill
3_