Epson Stylus Pro 4800 Setup Manual page 8

4. Slide the movable flange (removed in step 1)
onto the spindle and into the end of the roll
paper until it fixes into place.
Attaching roll paper to the printer
To attach roll paper to the printer, follow the steps
below.
1. Open the roll paper cover.
2. Make sure that the movable flange is fixed into
the end of the roll paper properly.
3. Hold the roll paper spindle so that the black
movable flange is on the left side. Then place
the spindle in the groove located on the top of
the printer.
Black movable flange
8
4. Move the paper lever to the released position.
5. Hold the both sides of the paper, and load the
paper in the paper insertion slot.
6. Pull the paper until it hangs down over the
paper tray.
Note:
If thin paper is loaded, press the Paper Feed
button to decrease the value of paper suction. If
thick and curled paper is loaded, press the Paper
Feed button to increase the value of paper
suction.