Epson Stylus Pro 4800 Setup Manual page 10

3. Lift up the paper tray cover, and then pull the
paper guide roller up.
4. Raise the paper guide, and then slide the edge
guide to the left slightly wider than the width
of your paper.
5. Fan a stack of paper, and then tap it on a flat
surface to even the edges.
If the paper is curled, flatten it before you load
it. If it curls excessively and jams frequently,
stop using it.
6. Clean the inside of the tray to remove any
dust. Dust may decrease the printout quality.
10
7. Load the sheets with the printable side facing
down and the right edge of the paper resting
against the right side of the paper tray.
Note:
❏ Always set the paper's short edge first.
❏ Make sure the sheets lie flat on the bottom of
the tray, and put the edge of the paper against
the right inner corner of the paper tray;
otherwise, printing may become misaligned.
❏ The loadable capacity of paper in the paper tray
differs depending on the media and its size.
The paper tray can hold up to 250-sheets of
17 lb or 64 g/m² plain paper. Do not load the
paper above the arrow mark on the inside
surface of the left edge guide.
For information on the loadable capacity of
Epson special media, see the following table.
Epson special Size
media
Premium A4
Semigloss Photo
LTR
Paper
A3
Super
A3/B
Premium Luster LTR
Photo Paper
A3
Super
A3/B
Photo Quality Ink A4
Jet Paper
LTR
EPSON Proofing Super
Paper Semimatte A3/B
(Commercial)
Loadable
capacity in the
paper tray
100
100
50
50
100
50
50
200
200
50