Epson Stylus Photo 785EPX Printer Basics Manual page 92

Roll paper doesn't feed correctly.
86
To load paper correctly, gently hold the paper in place with your hand
z
while you press the
printer. Allow the paper to feed automatically.
Use a triangle or other tool to make sure the end of the roll is cut
perpendicular to the edges. If the end is cut on a diagonal, the paper
may not feed smoothly.
If you see a paper jam error message, press the
for four seconds to clear the error.
b
If the red error light is on, press the
wait for the light to go off. Then press the
resume printing.
Remove the paper support and close the output tray extensions.
Always select
Roll Paper
(or
Feeder Auto Sheet Feeder
unnecessarily after each print job. In addition, a great deal of paper
may feed unnecessarily when you turn your computer off and then on
again.
If extra paper feeds after a print job or after you turn on the printer,
z
press the roll paper button for three seconds to rewind the paper.
(You may need to repeat this step to rewind the paper completely.)
b
Then press the maintenance button to turn off the
Finally, reload the paper and press the
resume printing.
z
Always press the roll paper button to feed roll paper. If you press
b
the maintenance button instead and then turn either the printer
or your computer off and on again, paper will feed unnecessarily and
you'll see a paper jam error message.
If paper is curled, roll the paper inside a folded sheet of paper in the
direction opposite to the paper's curl. You don't need to uncurl the
entire roll—only about 9 inches.
button. Don't force the paper to feed into the
b
maintenance button and
z
as the Paper Source setting. If
) is selected, paper will feed
z
roll paper button again to
z
roll paper button
roll paper button to
Sheet
b
error light.