Keychain Remote; Door/Window Sensor - X10 POWERHOUSE DS7000 Owner's Manual

Installation

Keychain Remote

BATTERY
ARM
DISARM
LIGHTS
ON
LIGHTS
OFF
Registering the Keychain Remote with the Security Console
• Fit two AAA Alkaline batteries in the battery compartment in the back of the Keychain
Remote.
• Press and hold the ARM button for about a second. The LED indicator flashes twice
when you release it. This confirms the Keychain Remote has generated a new random
security code.
• Set the slide switch on the Security Console to INSTALL.
• Press ARM. The console beeps once to confirm that the Keychain Remote has been
registered.
• Return the console slide switch to the RUN1 or RUN2 position.
Testing the Keychain Remote
• Set the slide switch on the Security Console to RUN1 or RUN2.
• Press ARM on the Keychain Remote. The console beeps once to confirm and the
ARM indicator lights. Press DISARM.
Note: The Keychain Remote always arms the system instantly - there is no exit or
entry delay.
• Press LIGHTS ON and LIGHTS OFF to turn on and off a light connected to a Lamp
Module with the same House Code and Unit Code as set on the Security Console.
• Press ARM and DISARM together to trip the panic alarm. Press DISARM to stop the
alarm.
PANIC
8
Installation

Door/Window Sensor

DOOR/WINDOW SENSOR
DELAY
MAX MIN
Ideal location
TEST
Installing the Door/Window Sensor
• Attach the Door/Window Sensor to the wall using the mounting screws provided.
• Fit the Door/Window Sensor as high as possible at the top of the door/window.
• Make sure the arrows on the magnetic switch halves are facing each other and that
they separate cleanly when the door or window is opened.
• Set the DELAY slide switch to MIN to always trigger the alarm instantly (for windows),
or to MAX to trigger the alarm after a preset entry delay when the system is armed in
DELAY mode (for doors) .
Registering the Door/Window Sensor with the Security Console
• Fit two AA Alkaline batteries in the battery compartment.
• Press and hold the TEST button for about a second. The LED flashes twice when you
release it. This confirms it has generated a new random security code.
• Set the slide switch on the Security Console to INSTALL.
• Press the TEST button on the Door/Window Sensor. The console beeps once to
confirm and the next available zone LED lights.
• Return the console slide switch to the RUN1 or RUN2 position.
Testing the Door/Window Sensor
• Set the slide switch on the Security Console to RUN2.
• Open the door or window with the sensor attached. The console beeps to
acknowledge and the zone LED lights.
DOOR/WINDOW SENSOR
Two windows (requires
accessory magnetic
switch pair)
DOOR/WINDOW SENSOR
Sliding window
9