Panel Functions - Epson Stylus Color 640 Service Manual

Epson stylus color ink jet printer service manual
Hide thumbs Also See for Stylus Color 640:
Table of Contents

Advertisement

EPSON Stylus Color 440/640/740

1.4.2 Panel Functions

Refer to Table 1-19 to Table 1-21.
Table 1-19. Panel Functions
Switch
1. Loads or ejects a paper.
Load/Eject
2. When the carriage is on the I/C replacement position, return
(within 2 sec.)
the carriage to the capping position.
Load/Eject
1. Starts the I/C replacement sequence.
(for 2 sec.)
1. Starts the printhead cleaning sequence.
Cleaning
2. In case it's in the ink low or ink out condition, starts the I/C
(for 2 sec.)
replacement sequence.
Cleaning
1. When carriage is on the I/C replacement position, return the
carriage to the capping position.
(within 2 sec.)
Table 1-20. Panel Function with Power On
Switch
Load/Eject
1) Starts the status print.
Cleaning
<Stylus Color 440, 640>
Changes the code page.
<Stylus Color 740>
Enters the Default setting mode.
Load/Eject
Enters the EEPROM Reset mode. (The Load/Eject LED blinks
+
for a few seconds.)
Cleaning
(Used only for resetting the maintenance error.)
NOTE 1:You can check the 1) firmware version, 2) protection counter
and 3) nozzle check pattern by performing this function.
NOTE 2:The code pages for Stylus Color 440, 640 are not opened.
NOTE 3:Since Stylus Color 740 have 2 specifications both the standard
and NLSP version, user can select some parameter and a
character table by communicating with the printed list.
NOTE 4:After you enter this EEPROM reset mode, go to Table 1-21.
Chapter 1
Product Description
Function
Function
(*1)
(*2)
(*3)
(*4)
Table 1-21. EEPROM Reset
Switch
Cleaning
Resets the EEPROM.
1. While the Load/Eject LED is blinking (for about 2 seconds),
press down the Cleaning switch for 10 seconds.
The following steps vary depending on the printer.
2.
[Stylus Color 440/640]
After 10 seconds, both Bk and CMY ink LEDs come
simultaneously.
[Stylus Color 740]
After 10 seconds, Load/Eject, Bk and CMY ink LEDs all
blink
simultaneously.
3.
[Stylus Color 440/640]
Confirming the both LEDs are ON, release the Cleaning
switch. The printer automatically starts initialization
operation to reset the specified addresses in the EEPROM.
[Stylus Color 740]
Confirming all 3 LEDs are blinking, release the Cleaning
switch. The printer automatically starts initialization
operation to reset the specified addresses in the EEPROM.
NOTE 5:Before you press the Load / Eject switch, be sure to enter the
EEPROM reset mode, referring to Table 1-20.
You can reset the below addresses in a EEPROM by
performing the EEPROM Reset operation.
1. 1) Timer Counter (Power Off time) IC value
2. I/F selection returns to Auto
3. Protection Counter value
Even though you repeat the EEPROM reset operation,
it does not perform initialization but only resets the
EEPROM addresses. Wheater or not to permorm
initialization depends on the power off time monitored
by the timer IC.
Revision A
Function
(*5)
ON
33

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stylus color 740Stylus color 460Stylus color 440

Table of Contents