Table of Contents
Advertisement
Necessary Settings before Use
Power/Mode
Switch
Access/C
harge
Lamp
)
Set Lever
MENU
Be sure to configure
the following
three
settings
before
use.
3
Connect the AC adapter.
To AC Outlet
(110V to 240V)
• The access/charge lamp blinks to
indicate charging has started.
• When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
| Set the power/mode
switch to OFF.
Slide while pressing down the lock button.
2 Attach the battery
pack.
Slide the battery pack down until it locks
in place.
BATT.--
Required charging / recording time
(approx.)
Battery pack Charging tirne
Recording
time
BN-VF815U
1 hr. 20 min.
2 hr. 40 min.
(Provided)
1hr. 25 min.*)
2 hr. 00 min.
BN-VF823U
3 hr. 50 min.
2 hr. 10 min.*)
3 hr. 45 min.
BN-V840U
4 hr. 00 min.*)
5 hr. 25 min.
BN-V856U
5 hr. 40 min.*)
* When using the viewfinder.
•
To detach
the battery
pack
Slide and hold BATT. (:_ step 2), then
remove
the battery
pack.
•
To check
the remaining
battery
power
See page 18.
16
Advertisement
Table of Contents
