Necessary Settings before Use
Access/Charge
Lamp
Set Lever
Be sure to confi gure the following 3 settings
before use.
Charging the Battery Pack
1
Set the power/mode switch to OFF.
Slide while pressing down the lock button.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
16
Power/Mode
Switch
OFF
(CHARGE)
BATT.
3
Connect the AC adapter.
DC Connector
AC Adapter
•
The access/charge lamp blinks to
indicate charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the power cord from the
AC outlet and disconnect the AC adapter
from the camera.
Required charging / recording time
(approx.)
Battery pack Charging time
BN-VF815U
2 hr. 40 min.
(Provided)
BN-VF823U
3 hr. 50 min.
* Using the LCD monitor
** Using the LCD monitor and the LED light
8 To detach the battery pack
Slide and hold BATT. (
remove the battery pack.
8 To check the remaining battery power
See page 18.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
To AC Outlet
(110V to 240V)
Power Cord
Recording
time
1 hr. 25 min.*
1 hr. 25 min.**
2 hr. 10 min.*
2 hr. 5 min.**
step 2), then