JVC DR-M10 Instructions Manual page 99

DISPLAY S ET
The boldface settings in the table below indicate the settings at your purchase.)
• SUPERIMPOSE
OFF
AUTO
• GRAYBACK
OFF
ON
When "SUPERIMPOSE" is set to "AUTO" and ON SCREEN on the Remote is
pressed, various operational indicators appear on the TV screen. To clear the
operational indicators, press ON SCREEN again.
You can select the modes of indications superimposed on the TV screen.
OFF:
[b turn off superimposed indications.
AUTO:
[b superimpose operational indications for approximately five
seconds just after the corresponding operation,
• DIMMER
BRIGHT
DIMMED1
DIMMED2
OFF
• POWERSAVE
OFF
ON
NOTES:
• When you use this unit as the source player for editing, be sure to set "SUPERIMPOSE"
to "OFF" before starting. (_z_ _ pg. 89, "Edit ]b Or From Another Recorder")
• When you select "AUTO", during playback, the operation mode indicators may be
disturbed depending on the type of disc being used.
When this function is set to "ON", the TV screen becomes all grey when
receiving a channel not in use.
NOTE:
When you want to receive an unstable _hannel with poor signals, set this function to
"OFE'.
You can change the brightness of the front display paneh
BRIGHT:
Normally select this.
DIMMED1/DIMMED2:
[b change the brightness level. (Blue lamp on the front display panel
become dimmer.)
OFF:
[b dim the front display paneh (Blue lamp on the front display panel
is turned off.)
NOTE:
It is impossible to turn off the light of the front display completely. When "BRIGHT" or
"DIMMED1 " is selected, the brightness level will be same as "DIMMED1" after the unit is
turned off. When "DIMMED2" or "OFF" is selected, the brightness level will be same as
"DIMMED2" after the unit is turned off.
When this function is set to "ON", you can reduce the power consumption
while the unit is turned off.
NOTES:
• During Power Save mode-
-- the front display panel will be turned off.
-- the lust Clock function does not work.
• Power Save does not work when --
the unit is in the Timer mode.
the unit's power is turned off after timer-recording or Instant Timer Recording.
-- the Satellite Auto Recording mode is engage(]. (_-_ pg. 71 )
• [t takes some time for the unit to complete initialisation after you turn on unit power,
with "WAKE UP" blinking on the front display panel.
• ON SCREENLANGUAGE
This unit offers you the choice to view on-screen messages in 3 different
languages.
For details, refer to "On-screen Eanguage Set" (_-_"pg. 22).