Troubleshooting - JVC DR-M10 Instructions Manual

.l O_ EN TROUBLESHOOTING
Before requesting service for a problem, use this chart and see if you can solve tile trouble yourself. Small problems are
often easily solved, and this can save you the trouble of sending your unit off for repair.
GENERAL
SYMPTOM POSSIBLE C AUSE CORRECTIVE A CTION
1. No power is supplied to the unit. • The AC power plug is disconnected from Connect the AC power plug to the mains
the mains, securely. (_-_ pg. 18)
2. The channel cannot be changed. • Recording or Live Memory recording is Press II to pause recording, change the
in progress, channel, then press I_ to resume
recording.
3. The Remote does not operate the unit. • The setting of the remote control code is Set the same remote control code (1,2, 3,
inappropriate, or 4) on both the unit an(] the Remote.
• The batteries are discharged. Replace the dead batteries with new ones.
4. Dubbing from the external equipment • The setting of the input channel position Select the input channel position ("F-1 ",
is not possible, is inappropriate. "L-1 ", or "L-2") that corresponds to the
input terminal connected to the external
equipment. (_-_" pg. 89)
5. The on-screen display superimposed Set "SUPERIMPOSE" to "OFF".
on the program played back/received (_-_" pg. 99)
on this unit is recorded when you dub
the program to an external recording
equipment.
6. The Remote does not work properly. Remove the batteries, wait for 5 minutes
or more, then load the butteries again.
• The batteries are discharged. Replace the dead batteries with new ones.
7. The unit does not operate. • There are cases when the operation is
prohibited on the disc.
• Lightning or static electricity may cause Press d)/[ on the unit or DVD_;/[ on the
malfunction of the unit. Remote to turn the power off, then press
the button again to turn the power on.
PLAYBACK
SYMPTOM . POSSIBLE C AUSE I CORRECTIVE A CTION
1. Images do not appear on the TV • The TV is not set to the AV mode. Set the TV to the AV mode.
screen, • When interlace scanned program is
played back, progressive scan mode is
selected,
• The disc is loaded upside (]own, 2. Playback dose not start or stop
immediately after playback is started
by pressing I_.
On the front display panel, "NO DISC"
appears.
• A disc not being compatible with the
unit is loaded.
• A dirty disc is loaded.
• Defective disc is loaded.
Press an(] hold PROGRESSIVE SCAN until
[_ disappears from the front display
paneh
Place the disc on the disc tray with the
playback surface facing downward,
(_ _'" pg. 11 )
Load a playable disc on the unit.
(_:_'" pg. 7, 8)
Clean the disc. (_" pg. 11)
Replace the warped or scratched disc with
a normal one.
3. Images are blurred or distorted when Images are blurred or distorted at the point
you start High-Speed Search. where the playback speed changes and
this is not a malfunction of the unit,
4. Playback does not start, Playback does not start for approximately
-- 30 seconds after recording is stopped and
this is not a malfunction of the unit,
5. Playback does not start when you • The Parental Lock is engage(] an(:] the Release the Parental Lock temporarily or
select a title or a chapter, disc is rate(] higher than the set level, change the set level, i_-_" pg. 53)