JVC DR-M10 Instructions Manual page 97

AUDIOOUTPUT
The boldface settings in the table below indicate the settings at your purchase.)
• DIGITALAUDIO OUT
Set to the appropriate mode according to the type of the device connected to
DOLBY DIGITAL/PCM DIGITAL OUT connector.
STREAM/PCM DOLBY DIGITAL/PCM:
PCM ONLY Select this when you connect the digital input connector of a Dolby
Digital decoder or an amplifier with a built-in Dolby Digital
decoder.
STREAM/PCM:
Select this when you connect the digital input connector of an
amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel
decoder.
PCMONLY:
Select this when you connect the linear PCM digital input of other
audio equipment (amplifieb MD or DAT deck, etc.).
• ANALOG AUDIO OUT
STEREO
DOLBYSURROUND
• D. RANGECONTROL
NORMAL
WIDERANGE
TVMODE
• OUTPUTLEVEL
STANDARD
LOW
Select the appropriate setting to accommodate the unit to the connected A/V
equipment. This function takes effect when a DVD VIDEO disc is played back.
STEREO:
Select this when listening to conventional two-channel stereo audio
with the unit's AUDIO OUTPUT connectors connected to a stereo
amplifiedreceiver or TV set, or in case you want to record the audio
from a DVD VIDE(-) disc to a Mini Disc, etc.
DOLBY SURROUND:
Select this when listening to multichannel surround audio with the
unit's AUDIO OUTPUT connectors connected to an amplifietf
receiver with a built-in surround decoder or a surround decoder.
The dynamic range (the difference between the loudest sound and the quietest
one) can be compressed during playback of a program encoded in Dolby
Digital format.
This function takes effect when a DVD VIDEO disc recorded in Dolby Digital
format is played back at low or middle volume.
NORMAL:
Normally select this setting to activate this function.
WIDE RANGE:
Select this to deactivate this function when you enjoy wide dynamic
range program.
TVMODE:
Select this when you hear the sound through the TV's speaker(s).
NOTES:
• This function takes no effect on programs other than that re_orded in Dolby Digital
format,
• This fun(tion dose not work when Simulated Surround Effect is activated. (_ pg. 50)
• The effect of "NORMAl" an(] "WIDE RANGE" may not be different depending on discs.
You can lower the output level of analog audio to accommodate the unit to the
connected A/V equipment.
STANDARD:
Normally select this setting.
LOW:
The output level of analog audio is lowered.