Download Print this page

Panasonic Lumix DMC-TS20 Owner's Manual page 7

Hide thumbs Also See for Lumix DMC-TS20:

Advertisement

Before Use
Handling
of the camera
• Waterproofing
is not guaranteed
if the unit is subject
to an impact
as a result
of being hit or
dropped,
etc. If an impact
to the camera
occurs,
it should
be inspected
(subject
to a fee) by a
Panasonic's
Service
Center to verify that the waterproofing
is still effective.
• When
the camera
is splashed
with detergent,
soap, hot spring,
bath additive,
sun oil, sun
screen,
chemical,
etc., wipe it off immediately.
• Waterproof
function
of the camera
is for sea water and fresh water
only.
• Any malfunction
caused
by customer
misuse,
or mishandling
will not be covered
by the
warranty.
• The inside of this unit is not waterproof.
Water leakage
will cause malfunction.
• Supplied
accessories
are not waterproof
(excluding
Hand Strap).
• Card and battery are not waterproof.
Do not handle with a wet hand. Also, do not insert wet
card or battery
into the camera.
• Do not leave the camera
for a long period of time in places where
temperature
is very low (at
ski resorts
or at high altitude, etc.) or very high [above 40 _C (104 °F)], inside a car under strong
sunlight,
close to a heater,
on the beach, etc. Waterproof
performance
may be degraded.
• About
the [Precautions]
demonstration
display
([Requirements
for
Underwater
use])
• [Precautions]
is displayed
when the power
is turned
on for the first time after purchase,
with the
side door completely
closed.
• Please check
beforehand
to maintain
the waterproof
performance.
1
Press
to select
[Yes],
and
press
[MENU/SET].
• It will automatically
skip to the clock setting
screen
if [No] is selected
before
it starts.
2
Press
•/1_
to select
the picture.
3
• : Return to the previous screen
I_:
View the next screen
• It can be forcefully
ended
by pressing
[MENU/SET].
• When
it is forcefully
ended while checking
by turning the unit off or pressing
[MENU/SET],
[Precautions]
is displayed
every
time the power is turned
on.
After
the final
screen
(12/12),
press
[MENU/SET]
to finish.
• When
[MENU/SET]
is pressed
after the final screen
(12/12),
[Precautions]
is not displayed
from the next time the power is turned on.
• This can also be viewed
from [Precautions]
(P45)
in the [Setup]
menu.
-7-

Advertisement

loading