Panasonic Inverter NN-T990SA Operating Instructions Manual page 19

f
All these things are normal:
The oven causes Some radio and "IV interference might occur when you cook with the
interference withmy "FV. microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, blow dryers, etc.. It does not
indicate e problem with your oven.
The oven lightdims. When cooking with a power other than P10 (HIGH), the oven must cycle to
obtain the lower power levels. The oven light will dim and clickingnoises
can be heard when the oven cycles.
Steam accumulates During cooking, steam and warm air ere given offfrom the food. Most of
on the oven door and warm the steam and warm air are removed from the oven by the air which
air comes fromthe oven circulates in the oven cavity. However, some steam will condense on
vents, cooler surfaces such as the oven door. This is normal.
I accidentally ran my Running the oven empty for a short time will not damage the oven.
microwave ovenwithout However, we do not recommend operating the microwave oven
any food in it. without any food in it.
PROBLEM ]
Oven will not turn on.
Oven will not start cooking.
POSSIBLE CAUSE /
I The oven is not plugged in
_ securely.
/ Circuit breaker or fuse is
") ! tdpped or blown.
| There is a problem with the
( outlet.
The door is not closed completely.
Start Pad was not pressed after
programming.
Another program is already
entered intothe oven.
The program is not correct.
StoplReset Pad has been pressed
accidentally.
ACTION 1
Remove plug from outlet, wait
10 seconds and reinsert.
Reset circuit breaker or replace
fuse.
Plug another appliance into the
outlet to check if it is working.
Close the oven door securely.
Press Start Pad.
Press Stop!Reset Pad to
cancel the previous program
and enter new program.
Program again according to the
Operating Instructions.
Program oven again.
"_ / The Glass Tray is not positioned
The Glass Tray wobbles. | .-), | properly on tha Roller Ring or there
) L is food under the Roller Ring.
When the oven is operating, 1.-_ [ The Roller Ring and oven bottom
thethereGlassiS noiSeTray.COming from I I l are dirty.
The word "Lock" appears in 1 I Function Kay Pad has been activated.
the Display Window. J--)
L
Take out Glass Tray and Roller Ring.Wipe
with a damp cloth and reset Roller Ring and
Glass Tray propedy.
Clean according to Care of Your Microwave
Oven.
Refer back to Function" Child Lock"Pad
Operation on page 9.
]
-17-