Panasonic TC-P42G10 Operating Instructions Manual page 51

Automatically searches and adds a vailable channels tothe memory.
Select " ANTin" _3_ Select a
scanning mode (p. 17)
÷ Select Cable or Antenna
Or select "Not used" (p. 16). - @ok
Select "Auto program"
select
Settings are made automatically
÷ After the scanning is completed, select "Apply".
(see below @).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode" (p. 36)
Select "Edit"
(2) Select the item to be edited
Caption Add Changes the station identifier
Favorite:
Registers channel to Favorite
List
L_ ÷ Add:
_ Proceed to Adds or skips channels
next page
Go back to previous page
(3) Edit
® Caption
Select the station identifier (maximum 7 characters available)
® Favorite
/ _select
<:,next
Set favorite] Select the number
® Add RETURN
Press OK to select "Yes (add)" or "No (skip)"
(4) Move cursor to channel number
Select
To cancel the Edit
Check the signal strength if an interference is found or freezing occurs on a digital image.
_ _ /'" ;:--®, ® If the signal is weak, check the antenna.
_ _ _,:,, _ If no problem is found, consult your local dealer.
oK _ ,ybcnanae
_ _ or L
_)
....
channel
® Not available if "Cable" is selected in "ANT in"
Signal intensity (see above).
® Available only for digital antenna channels.
® If "Lock" (p. 48) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
51
@
m
m,
5"
G:3
.m
00
d)
5"
G:3
C)
::Y
"m
"m
d)