Select Dot Size "Esc - Epson STYLUS 870 Programming Manual

6.17 Select dot size "ESC (e nL nH m d"
Format:
ASCII
Hex
Decimal
Range of Values for Parameters:
nL=02H, nH=00H
m=00H, d=00H, 01H, 02H, 03H, 04H, 10H
Function:
1) The dot size is set according to the value of d.
2) The parameter has the following meaning:
d=00H:
..................for a 720 dpi raster, Normal x1,2 dot
3) The defaults are specific to each model of printer.
4) Dot control is valid irrespective of printing mode and printing density.
5) If the dot size is changed part way through a page, the results are unpredictable.
6) If n has any value other than the above, this command is ignored.
Initial State: Default
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
The default is set by the ESC @ command.
The default is set by the ESC (G command.
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
None
EPSON Imaging Technology Center
Revision: 1
ESC ( e
1B 28 65
27 40 101
default
for a 360 dpi raster, Normal x3dot
nL nH m
nL nH m
nL nH m
d
d
d
Page: 38
10/6/00