Lockout / Tagout Procedure; Service & Parts Information - Vulcan-Hart VRH8 ML-152020 Installation & Operation Manual

VRH SERIES OVENS
removing any sheet metal panels or attempting to service this
equipment.
The Lockout / Tagout Procedure is used to protect personnel working on an electrical
appliance. Before performing any type of maintenance or service on an electrically operated
appliance, follow these steps:
1. In electrical box, place unit's circuit breaker into OFF position.
2. Place a lock or other device on electrical box cover to prevent someone from placing
circuit breaker ON.
3. Place a tag on electrical box cover to indicate that unit has been disconnected for
service and power should not be restored until tag is removed by maintenance
personnel.
4. Disconnect unit power cord from electrical outlet.
5. Place a tag on cord to indicate that unit has been disconnected for service and power
should not be restored until tag is removed by maintenance personnel.
To obtain Service and Parts information concerning this model, contact the Vulcan Service
Department at the address listed on the front cover of this manual or refer to our website:
www.vulcanequipment.com
When calling for service, have the model number and serial number available.

LOCKOUT / TAGOUT PROCEDURE

Always perform the Lockout / Tagout Procedure before
SERVICE & PARTS INFORMATION
for a complete listing of Authorized Service and Parts depots.
Customer Service
Technical Service
Service Parts
1-800-814-2028
1-800-814-2028
1-800-814-2028
18
F-41207 (11-12)