Initial Ink Charge - Epson SEIJ98006 Service Manual

EPSON Stylus Color 900

5.2.7 Initial Ink Charge

This section describes how to perform Initial Ink Charge. It must be
performed under the following conditions.
1. C265 Main Board has been replaced.
2. The printhead has been removed. (Be sure to perform Ink
Cartridge Replacement Sequence before performing Initial Ink
Charge.
3. Nozzles are badly clogged. (Cleaning using the program and
control panel has been done, but the nozzles are still clogged.)
1. It is advisable that the currently installed ink cartridges be replaced
with new ones. (If ink runs out during the operation, Initial Ink charge
begins again when a new I/C is installed.)
2. Referring to Section 5.2.1, perform the preliminary operation.
3. Select "Maintenance" from the main adjustment menu.
4. Select "Ink Charge Flag Reset".
5. The following screen appears.
Figure 5-44. Screen after "Ink Charge Flag Reset" is Selected
Adjustment
6. Select "Yes".
7. The following screen appears.
Figure 5-45. Message during Ink Charge Flag Reset Operation
8. Turn the printer off.
9. Leave the printer as it is for 10 seconds.
10. Turn the printer back on. The printer performs Initialization and then
Initial Ink Charge in sequence.
Adjustments
Revision C
154