Printer Mechanism Removal - Epson SEIJ98006 Service Manual

EPSON Stylus Color 900

4.2.2 Printer Mechanism Removal

1. Remove the upper case. (See Section 4.2.1.)
2. Unlock the cable clamp on the relay board, then take all harnesses
out of the cable holder.
Screws securing the
Printer Mechanism
Screws securing the
Waste Ink Drain Pads
Figure 4-4. Printer Mechanism Removal
3. Disconcert the following connectors from the relay board. (The
connectors to be disconnected are colored red in Figure 4-5.)
Disassembly and Assembly
Cable Holder
Relay Board
Screw securing the
Printer Mechanism
Printhead FFCs
Disassembly Procedures
When assembling, be sure to connect the connectors
properly as shown in Figure 4-5.


19-pin FFC (used to supply sensors with power and to send
condition detection signals)


2-pin connector for driving the solenoid


Connector for ASF


Connector for PF motor


Connector for Pump/ASF motor


Connector for PE sensor


Connector for CR motor


Connector for CRHP (Carriage Home Position) sensor
Figure 4-5. Connector Location
Revision C
107