Removing Holder, Shaft Assy - Epson Stylus Photo R310 Service Manual

Stylus Photo R300/R310

2.3.9 Removing Holder, Shaft Assy.

External View
Cable, Head
80-Place Side
Carriage Unit
Ribs
1
Figure 2-20. Removing "Holder, Shaft Assy." (1)
DISASSEMBLY AND ASSEMBLY
2
Dowel
C.B.S 3x6
(6-8kgf•cm)
Paper Guide,
Upper
PE Sensor Lever
Holder, Shaft Assy.
2
Parts/Units which should be removed before removing "Holder, Shaft Assy."
Paper Support Assy./Housing, Upper/Housing, Middle/Main Board Unit/
ASF Assy.
Procedure for Removing
1. Move "Carriage Unit" toward 80-Place Side.
2. Remove the screws (x2) which secure "Holder, Shaft Assy.".
3. Pull "Holder, Shaft Assy." upward and release the hooks (
tweezers or alike. Then, Release the dowel from "Ink System Frame".
4. Looking at the printer from its back side, press down "Paper Guide, Upper" on
the left, and release "PE Sensor Lever" from the slot. Remove "Holder, Shaft
Assy." by sliding it to the right.
Be careful not to damage "PE Sensor Lever" and "Paper Guide,
Upper" when removing them since "PE Sensor Lever" contacts
with "Paper Guide, Upper".
5. Release "Cable, Head" from the hooks (
Do not damage "Cable, Head".
Disassembly
Revision A
1 : x2) with the
2 : x7) of "Holder, Shaft Assy.".
51