Offset Jobs; Staple - Kyocera TASKalfa 250ci User Manual

Finishing
2
3
4
5

Offset Jobs

Offsetting Jobs
1
2
3
4

Staple

6-2
Select a number of copies greater than 1.
In Finishing > Separation, select Rotate copies.
Click OK to return to the Print dialog box.
Click OK to start printing.
The Offset jobs feature physically shifts each print job in the output tray.
To ensure consistent offset stacking, all users printing to the same printing
system should select Offset jobs as the default setting.
The Offset jobs feature requires a finishing device to be selected under Device
options in the Device Settings tab. It does not work with the Staple or the
Finishing edge features.
You can offset, or shift each print job in the output tray.
In the Basic tab, under Destination, select from these options:
1000-sheet finisher: Printer default or Finishing tray (face-down)
3000-sheet finisher: Printer default or Tray A (face-down)
Open the Finishing tab, then select Separation > Offset jobs.
Click OK to return to the Print dialog box.
Click OK to start printing.
The Staple feature lets you create stapled document sets. You must first select
a finisher under Device Settings > Device options. Selecting the Staple
feature makes Separation and Transparency interleaving unavailable. The
maximum number of sheets depends upon the finisher model and the selected
Page size or Media type. The Gutter feature lets you increase the top and left
margins to accommodate the location of the staples.
Staple and Separation features cannot be used together.
If Printer default is selected as the Destination in the Basic tab, the selection
of an option in the Finishing tab results in the automatic selection of a
destination compatible with that finishing option. The destination is
automatically updated to the first available output tray that supports the selected
finishing option.
Staple selects the Destination automatically. If the Finishing options are
changed, the Destination selection is not affected.
Finishing edge should be selected before any other features in the Finishing
tab. If set last, Finishing edge might change any settings that you previously
made under Staple.
User Guide