Usb 2.0 Support; Serial Ata - Intel DX58SO2 Product Manual

Intel Desktop Board DX58SO2 Product Guide
Table 3 describes the LED states when the board is powered up and the LAN
subsystem is operating.
Table 3. LAN Connector LEDs
LED LED Color
A Green
B N/A
Green
Yellow
C Green
D N/A
Green
Yellow

USB 2.0 Support

The Desktop Board supports USB 3.0 and USB 2.0. USB 3.0 is supported via two
USB 3.0 ports (blue) on the back panel. USB 3.0 ports are backward compatible with
USB 2.0 and USB 1.1 devices. The USB 3.0 ports are SuperSpeed, high-speed, full-
speed, and low-speed capable. USB 3.0 support requires both an operating system
and drivers that fully support USB 3.0 transfer rates.
There are 12 USB 2.0 ports (six ports routed to back panel connectors (black) and six
ports routed to three onboard headers). The USB 2.0 ports are high-speed, full-speed,
and low-speed capable. USB 2.0 support requires both an operating system and
drivers that fully support USB 2.0 transfer rates.

Serial ATA

The board provides two onboard 6.0 Gb/s Serial ATA (SATA) channels (blue
connectors) and six onboard 3.0 Gb/s SATA channels (black connectors).
The onboard Serial ATA channels provided by ICH10R support the following RAID
(Redundant Array of Independent Drives) levels:
• RAID 0 - data striping
• RAID 1 - data mirroring
• RAID 0+1 (or RAID 10) - data striping and data mirroring
• RAID 5 - distributed parity
18
LED State Indicates
Off LAN link is not established
On LAN link is established
Blinking LAN activity is occurring
Off 10 Mb/s data rate
On 100 Mb/s data rate
On 1000 Mb/s data rate
Off LAN link is not established
On LAN link is established
Blinking LAN activity is occurring
Off 10 Mb/s data rate
On 100 Mb/s data rate
On 1000 Mb/s data rate