Electrical Requirements - Jenn-Air JGC9430BDB Installation Instructions Manual

Cabinet Dimensions
IMPORTANT: If installing a range hood or microwave hood
combination above the cooktop, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
C
K
M
J
" "
A. 30 (76.2 cm) on 30
B. Combustible area above countertop (shown by dashed
box above)
"
C. 30 (76.2 cm) minimum clearance between top of cooktop
platform and bottom of uncovered wood or metal cabinet
"
(24 [61 cm] minimum clearance if bottom of wood or metal
cabinet is covered by not less than
millboard covered with not less than No. 28
MSG sheet steel, 0.015
"
0.024 [0.06 cm] aluminum or 0.020
"
D. 13 (33 cm) recommended upper cabinet depth
"
E. 2 (5.4 cm)
"
F. 19 (50.6 cm)
G. 18" (45.7 cm) minimum clearance from upper cabinet to
countertop within minimum horizontal clearances to cooktop
H. Grounded outlet - Locate within 24" (61 cm) of right rear
corner of cutout (with no undercounter built-in oven installed
below cooktop)
I. 28½" (72.4 cm) on 30" models; 34½" (87.6 cm) on 36" models
J. 6" (15.2 cm) minimum distance to nearest left and right side
combustible surface
K. 1" (2.5 cm) minimum distance to rear combustible surface
L. Gas line opening - Wall: Anywhere 6" (15.2 cm) below
underside of countertop. Cabinet floor: anywhere within
6" (15.2 cm) of rear wall is recommended (with no
undercounter built-in oven installed below cooktop)
M. 23 " (58.6 cm) minimum countertop depth is required
NOTES: After making the countertop cutout, some installations
may require notching down the base cabinet side walls to clear
the cooktop base. To avoid this modification, use a base cabinet
with sidewalls wider than the cutout.
If cabinet has a drawer, a 4" (10.2 cm) depth clearance from the
countertop to the top of the drawer (or other obstruction) in base
cabinet is required. The drawer depth may need to be shortened
to avoid interfering with the regulator.
IMPORTANT: If an undercounter built-in wall oven is to be
installed below this cooktop, the grounded outlet (H) and gas
supply piping must be located in an adjacent cabinet.
This cooktop and its gas and electrical supply sources must be
installed before the undercounter built-in wall oven is installed.
4
A
D
B
F G
E
H
L
I
" "
models; 36 (91.4 cm) on 36 models
"
[0.6 cm] flame retardant
"
[0.04 cm] stainless steel, or
"
[0.05 cm] copper)

Electrical Requirements

IMPORTANT: The cooktop must be electrically grounded in
accordance with local codes and ordinances, or in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70
or Canadian Electrical Code, CSA C22.1.
This cooktop is equipped with an electronic ignition system that
will not operate if plugged into an outlet that is not properly
polarized.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit is
J
required. A time-delay fuse or circuit breaker is also
recommended. It is recommended that a separate circuit
serving only this cooktop be provided.
Electronic ignition systems operate within wide voltage limits,
but proper grounding and polarity are necessary. Check that
the outlet provides 120-volt power and is correctly grounded.
The wiring diagrams are provided with this cooktop. See
"Wiring Diagrams" on a separate sheet.
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575