Jenn-Air JS42NXFXDW00 Installation Manual page 18

Install Door Panels
1. Lower the panel mounting bracket onto the adjustment pins at
the top of the door.
C
A. Door panel
B. Mounting bracket
2. Slide the studs, on the back side of the door panel, into the
"J" pockets in the front of the door.
3. Repeat steps 1 and 2 to install the second door panel.
4. Using slotted hex head screws (provided), attach the
mounting bracket (factory installed), located at the bottom of
the refrigerator and freezer doors, to the respective door
panels. Do not fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
18
A
B
C. Adjustment pins
B
Install Top Grille Panel
Flush Grille - Standard Installation
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2. Pull the grille panel down slightly to lock into place.
Full Height Grille - Integrated Installation
1. Align the bracket with the mounting posts.
2. Push the grille panel forward until the bracket snaps into
place.
B
A. Top grille panel
B. Cabinet sides
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the
refrigerator door(s) can open freely. If the door(s) opens too wide,
install the door stop pin (provided).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a " Allen wrench, tighten the door stop pin.
A. Door stop pin hole
A B
A