Section 2: Circuit Requirements; 110V Operation - Grizzly G7943 Owner's Manual

SEcTIOn 2: cIRcUIT REQUIREMEnTS

110V Operation

Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO nOT connect the machine to the
power source until instructed to do so.
Amperage Draw
the ⁄ hp motor on the Model g7943/g7944 will
3
4
draw the following amps:
Motor draw .............................................. 9 amps
circuit Requirements
Whether you have a dedicated or shared circuit,
only connect your machine to a circuit with
a verified ground, correctly sized wiring, and a
properly rated circuit breaker. obey all applicable
safety and electrical codes, including the national
electric Code (neC). If you are unsure about
any wiring practices, consult a qualified elec-
trician.
Minimum Circuit requirement ................. 15 amp
Plug/Receptacle Type
included plug type ........................... neMa 5-15
figure 3. typical type 5-15 plug and receptacle.
-12-
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure
checking with a qualified
electrician!
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO nOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension cords
We do not recommend the use of extension
cords. if you find it absolutely necessary to use
an extension cord with your machine:
• use at least a 10 gauge cord that does not
exceed 50 feet in length!
• the extension cord must also contain a
ground wire and plug pin.
• a qualified electrician Must size cords over
50 feet long to prevent motor damage.
Model g7943/g7944 (Mfg. 10/02+)
compliance by