Setup - Custom Audio Electronics Neo User Manual

GB

SETUP

Go into SETUP mode by pressing Key
1.
FEED and Key PRINT and turn power on at
the same time.
2. The printer should print all list of the
parameters:
- Printer emulation:
DPT24, CUSTOM DPT42 or CBM
iDP560RS .
(1)
- Protocol : No Addressable* or Addressable
(1)
- Baud Rate : 57600, 38400,19200 *,9600,
4800, 2400, 1200.
(1)
- Data length : 7, 8 bits/chr *
- Parity : (1) 7, 8 bits/chr *.
- Handshaking : (1) XON/XOFF* or Hardware.
- Autofeed: CR disabled* or CR enabled
- Panel keys: Enabled* or disabled.
- Print mode: Normal* or Reverse.
With "ESC/POS " : ä
Chars / line: A=32 / B=42 col. * or
A=42 / B=56 col.
With CBM iDP560RS : "
Font dimens :
40 col.
With CUSTOM DPTxx : "
Font type : Font A* o Font B.
- Speed: Normal* or Low.
- Offline (1)(2) : Disabled* or enabled
- Print density: Normal*, Dark, Light.
Notes: The parameters indicated with a *
symbol are the default values.
(1) NOTE: Parameter valid only on serial printer.
(2) NOTE: Using this parameter, it is possible to
select whether the Busy signal is activated
when the printer is both in Off Line status
and the buffer is full, or only if the reception
buffer is full.
14
TM
ESC/POS * , CUSTOM
.
"
18x24* 24 col. o 11x24
"