Table of Contents
Advertisement
Redial
The redial/p key redials the last number dialed. The redialed number can be up to 32
digits long.
Tone Dialing Switch-over
Some telephone companies use equipment that requires
pulse dialing (sometimes referred to as rotary dialing). If
you need to enter tone dialing digits, you can switch-over
to tone dialing during the call. For example, entering your
bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your call connects, press
*
/tone/
. Enter the desired number. These digits will be sent as tone dialing.
Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise
increases. If you pass the range limits of the base unit, your call will terminate
within 5 minutes.
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number
can be stored in a
memory location. This
is referred to as Chain
Dialing (See page 26.)
B A S I C S
[ 19 ]
Advertisement
Table of Contents
