Canon imageCLASS MF5950dw Settings Manual page 18

Appendix
Checking the Wireless LAN Setting is Completed
1.
Press [ ] (Status Monitor/Cancel).
2.
Select with [ ] and [
Status Monitor/Cancel
TX Job
RX Job
Fax Forwarding Erro
Network Information
3.
Select with [ ] and [
Network Information
IPv4
IPv6
Wireless LAN Informa
IEEE802.1X Error Inf
4.
Select with [ ] and [
IPv4
IP Address
Subnet Mask
Gateway Address
Host Name
5.
Take note of the IP address.
IP Address IP A P d A A dress
6.
Press [ ] (Status Monitor/Cancel) to close the
screen.
7.
Start the web browser of a computer which is
connected to a network.
Appendix-1
], and then press [OK].
...
], and then press [OK].
...
...
], and then press [OK].
8.
Enter http://<IP address of the machine>/ in the
address field, and then press the [ENTER] key on your
keyboard.
The <IP address of the machine> is the address
5
noted in step above.
http:// http:// / / / / /
9.
Check that the screen of the Remote UI is displayed.
When the Remote UI is not displayed
Perform steps 1 to 9 again.
IF the RUI is still not displayed, please refer to
the following;
Proceed to "The Remote UI is not displayed, " on p. 2-5.