Character Fonts; Printer Settings - Epson LQ-300 Manual

EPSON LQ-300
Lights and buttons
Pause Light
The Pause light is
orange
printing. Each time you turn on the printer, the light
flashes briefly.
When the printer is out of paper, the light flashes and the
beeper sounds three times. The light also flashes when
you can tear off the last sheet of continuous paper at the
edge of the printer cover.
The POUS light goes on and the beeper sounds ifan
error occurs.
Font 1 and Font 2 lights
The green Font lights,
Font
button
Press the Font
button during normal operation to cycle
.
through the printer fonts listed on the control panel.
press the button, the
you
indicate your current selection.
you hold down the
printer, you enter the Printer Setting mode, where you can
change many of the printer's settings. '
During normal operation, you can press this button
briefly to feed paper line by line. Hold it down to load a
single sheet, or to advance continuous paper to the next
top-of-form position. You can also press LF/FF to *a
If you want to make sure the printer is working correctly,
you can also use this button to run the self test To start
the self test, hold down the U=/FF button while you turn
on the printer.
Pause button
Press the POW button to stop the printer temporarily
during printing or the self test. Press it again to resume
activity.
Paper Park
Press the Font arsd LF/FF buttons together to feed
continuous paper backward to the paper-park position.
Micro Adjust
While in this mode, you can adjust the loading position by
pressing the LF/FF button or the Font button.
EPSON LQ-300-4
on when the printer stops
1 and 2, indicate the current font
Font lights
change
Font
button while you turn on the

Character Fonts

To choose one of the seven internal fonts listed on the control
panel, press the Fo$ button. The two font lights come on (0),
go off(O), or flash (0) to show the current. selection. Press the
button repeatedly to cycle through all of the available
selections; stop when you reach the desired font
Your Action stays in effect until you change it again or turn
off the printer. However, any font choices you make with
your software will cancel your control panel selection. The
how the Font lights
table below shows
selection.
EPSON Roman
EPSON Sans Setif
EPSON Courier
EPSON PrWige
EPSON Sctipt
EPSON Dmlt
=ofi 6sflashing

Printer Settings -

Your printer has internal settings that control simple
functions such as the page length and character set. These
settings take effect each time you turn on the printer, so they
are also called default settings.
For most users, the factory sett@s are best, but you can
lists all the settings you can change.
10/2/94
appear for each
Font LigW
0 0
0 l
0
0
0
l l
The table on the next page
Dot Matrix Printers