Installing The Power Cord - Epson LQ-1500 User Manual

have commands for setting top and bottom margins and they work
best if the skip-over-perforation feature is turned off.
Switch 2-6--There are occasions when the printer bell (which is actu-
ally a buzzer) can be used to signal the operator. For example, you
may want to switch paper in the middle of a long document. You can
use the bell to signal when it is time to make the change, To make use
of this feature, leave switch 2-6 down in the down position. For a
rough draft, it may not be necessary to switch paper, so by turning
switch 2-6 up, you won't be bothered by unnecessary noise. Gener-
ally, switch 2-6 is left in the down position.
Switch 2-7--This switch also selects a feature that you may want to
use one way for rough drafts and another way for the final printout.
You can select either letter quality printing or draft printing. The
LQ-1500 prints much faster in draft mode, but the quality isn't as
good. You can also change between draft and letter quality printing by
using commands sent from your computer.
Switch 2-8--This switch is used to control the select signal. Most com-
puters require that the select signal be fixed (switch is in the up posi-
tion). If your computer requires that the select signal not be fixed, then
set the switch in the down position.
If you have a parallel interface card, your installation is now com-
plete! Go on to Chapter 2, where you'll learn how to operate the
LQ-1500.
If, on the other hand, you have a serial or IEEE 488 interface card,
you have a few more switches to set in order to ensure that your com-
puter and LQ-1500 are communicating properly. Consult your inter-
face user manual for instructions on the proper setting of these
switches.

Installing the Power Cord

If you have been following along so far you should have one piece
left: the power cord. Plug one end into the LQ-1500--the connection
is on the rear of the printer near the right side (as you face the rear).
Plug the other end into a standard (120 VAC, 60 Hz) grounded electri-
cal outlet (do not use an adapter plug).
24