Grandstream Networks GXP1100 User Manual page 36

Use NAT IP
STUN Server
Settings -> Call Features
Off-hook Auto Dial
Off-hook Timeout
Disable Call Waiting
Disable Call Waiting Tone
Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Enable MPK sending DTMF
Disable Transfer
In-call dial number on pressing
transfer key
Auto-Attended Transfer
Do Not Escape # as %23 in
SIP URI
Click-To-Dial Feature
Call History Flash Writing:
Write Timeout
Call History Flash Writing:
FIRMWARE VERSION 1.0.5.23
The NAT IP address used in SIP/SDP messages. This field is blank at
the default settings. It should ONLY be used if it's required by your ITSP.
The IP address or Domain name of the STUN server. STUN resolution
results are displayed in the STATUS page of the Web GUI. Only
non-symmetric NAT routers work with STUN.
Configures a User ID/extension to dial automatically when the phone is
off hook. The phone will use the first account to dial out. The default
setting is "No".
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default value is 30 seconds.
Disables the call waiting feature. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disables the Conference function. The default setting is "No".
Enables Multi Purpose Key to send DTMF during the call. The default
setting is "No".
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
GXP1100/GXP1105 USER MANUAL Page 36 of 49