Sony CMT-DV2D Operating Instructions Manual page 46

Notes on discs
• Belbrc playing, clean the disc _ith a cleaning cloth.
Wipe the disc from the center out.
• Do net use selvents
such as benzine, thinner,
commercially available cleaners or anti-static spray
intended fer vinyl LPs.
• Do not expose the disc to direct sunlight or heat
seurces such as het air ducts, her leave it
ill
a car
parked in direct sunlight.
• Do not use discs encircled with a protectien ring.
This may cause a malfunctien to the system.
• When using discs that have glue or similar tacky
substance on the label side of the disc or that used a
special ink when the label was printed, them is a
chance that the disc or label may become attached to
parts inside this unit. When this eccurs, it may not be
possible to remove the disc, md may also cause this
unit to malfunction. Be sure to check that the label
side of the disc is not sticky beferc using.
The fellex_ing types of disc should net be used:
Rental or used discs with attached seals where the
glue extends beyond the seal. The perimeter of the
seal on the disc is tacky.
Discs thlt have labels printed using a special ink
that llaels tacky when touched.
Cleaning the cabinet
Clean the cabinet, ?anel and centrols _ith a sol'l cloth
slightly moistened with mikl detergent solution. Do net
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzine or alceheh
To save a tape permanently
To prevent a ta?e from being accidentally rccerded
ever, break off the cassette tab fiem side A or B as
ilhlstrated.
__ Break off the
"" cassette tab '\\ "_--
If yeu later want te reuse the tape fer recerding, cever
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take u? any slack in the tape. Otherwise, the ta?e may
get entangled ill the pal_s of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is ve U elastic. De net change the tape
operations such as play, step, and fast-winding
frequently. The tape may get entangled ill the tape
deck.
Cleaning the tape heads
Clean the ta?c helds afler every 10 hours ef use. Be
sure te clean the tape heads before you start an
important recording er after pl@ng an old tape. Use a
separately seld dry-type or wet4ype cle ruing cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape after evel 3' 20 to 30 hours of
use with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
46GB