Still Mode; Sleep Timer - Sylvania LD320SS8 Owner's Manual

[] Channel Selection
Selectchannels b y pressing [CH•/V] or [the Numberbuttons],
• To select the memorized channels, use [CH •Iv] or
[the Number buttons],
• To select the non-memorized channels use
[the Number buttons].
To Use [the Number buttons]
- When selecting analog channel 12
[] Volume Adjustment
Thissection describes h owto adjust the volume, T hemutefunction, w hich
turnsthesound off andon,isalsodescribed,
Use[VOL. / ]toadjusttheaudiovolume,
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear
in a few seconds.
Press [MUTE D_(]to turn offand on the sound.
M U F_
- When selecting digital channel 12-1
Be sure to press [-] before entering the minor
channel number.
• "Mute" is displayed on the TV screen for a few
seconds.
Press [MUTE 0_] again or [VOL. _/ ] to recover the
original volume.
• Press [CH RETURN] to return to the previously viewed
channel.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
NTSC (analog mode) lAir Time]
18:00
18:30
19:00
19:30
20:00
20:30
major ch_
:change automatically
_:> :change manually by using [CI-I •/V]
ATSC (digital mode)
[ J
i
minor channel
Note:
• "No Signal" will appear on the TVscreen after the minor
channel broadcast is over.
[] Still Mode
Youcanfreezethe imageshown onthe TVscreen,
Press [PAUSEII] to pause the image shown on the
screen.
• The sound output will not be paused.
• If no signal is detected or protected signal is received
during still mode, the image remains paused and the
sound output will be muted.
• The still function will be released after 5 minutes.
To cancel still mode, press any button except [POWER].
[] Sleep Timer
Thesleeptimer can beset toautomatically turnoffthe unit after an
incremental periodof time.
Press [SLEEP] to set the sleep timer.
• Sleep timer display appears on the TV screen.
2 Press [SLEEP] repeatedly to change the amount of time
until shut off.
i
z!
%1!
Z
• You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After set up, the sleep timer display can be called up
for checking by pressing [SLEEP].
if!if!
z
EN