Audio Out; Rf Output Channel - Magnavox MWD2206 Owner's Manual

Connections
Please refer to "Basic TV Connection" on the front page before you use this unit.
if channel 3 has been already occupied
for broadcasting,
1) Set your TV to channel 4.
2) Insert a pre-recorded tape into this unit.
3) Press [SOURCE] on the unit so that the
VCR OUTPUT light is lit.
If noise appears on the TV screen, press
[VCR/TV] on the remote control.
4) Press [PLAY _] once.
5) After a few seconds, press and hold
[PLAY I_] on the unit for 3 seconds.
• The RP output channel will change to
channel 4 from channel 3 and you will
see a playback picture.
• When a picture does not appear on the
TV screen, repeat step 4.
6) Press [STOP Ill to stop playback.
flint
The RFoutputchannel m aynot
change whenyouadjusttracking dur-
ingplayback. I nthiscase,stopthe
playback, a ndstarttheplayback again.
Afterthat,pressandhold[PLAY_-]
on heunit for3 seconds a gain.
Cab,e box or Backof 0V0NOR
Satellite
box) [,_ [!1 111_=3!11 /
:}atellite
oral _ _.H |
CableTV [1_
II J___!/_,_:_"l'5 [I_
RF cable [
Select this connection when you want to view or record a
scrambled channel. With this connection, channels cannot be
changed on the unit. You can view or record ONLY
the channels you have selected on the cable box or the
satellite box.
• While you are recording, only the recorded channel can be viewed.
Stereo system
To select channels of the cable box or satellite box
1)Turn on the unit by pressing [STANDBY-ON], then press
[VCR/TV]. The POWER ON indicator on the front panel
will light, then press [SKIP/CH. m/A, _/V] to select
channel 3 or 4 (the same channel as the output channel of
the cable box or satellite box).
• If you use the channel 4, you need to change the unit's
RF output to channel 4. Refer to "RF Output Channel".
2) At the TV, select channel 3 or 4 (the same channel as you
have selected at step 1).
3) On the cable box or satellite box, select the channel you
want to view or record.
Audio cable
(supplied)
AUDIO OUT
(Analog)
or
Analog audio
input jacks
Dolby Digital decoder,
IVlD deck or DAT deck
_ Digital audio
c[
_ , input jack
Audio Coaxial
Digital cable
(commercially _-
available)
DIGITAL
AUDIO OUT
(DVD mode only)
Hi.t
Playing a DVDusingincorrect settingsmaygenerate noisedistortion andmay
aso damage thespeaker.
Connecting to a Dolby Digital decod-
er for Dolby Digital audio output.
Connecting to the other equipment
(an MD deck or DAT deck etc.) with-
out Dolby Digital decoder.
* To complete these settings, refer to pages 20-21.
Hi t
Theaudiosourceon a discin a DolbyDigital M ultichannel surround format
I cannotberecorded as digital s oundbyan MDor DATdeck.
oBy hooking this unitupto a Multichannel D olbyDigital d ecoder, y oucan enjoy
high-quality D o]byDigitalMultichannel s urround soundasheardin themovie
I theaters.
° Playing a DVDusingincorrect s ettings maygenerate noisedistortion andmay
a sodamage thespeakers.
6 EN