Table of Contents
Advertisement
Press POWER to turn on the TV/DVD.
See2tt_echa_e
_umber
Press CHANNEL(CH.) A/_' to select your desired
channel number, or press the number buttons.
Notes for using the number buttons on the remote
control:
* You must proceed single-digit channel numbers
with a zero (Example: 02 ... 09).
* When selecting cable channels which are higher
than 99, press +100 first, then press the last two
digits. (Example: to select channel 125, first press
+100, then press 2 and 5).
Remember:
®If the TV/DVD is connected to a cable box or
satellite box, the TV/DVD must be on CH3 or
CHd, then the channel to be viewed must be select-
ed on the cable box or satellite box.
Press VOLUME(VOL.)
A/V to
adjust the volmne.
VOLUME 2O
l|||||nnnnn
NOTE:
* If you press CHANNEL(CH.) A/V in the DVD
mode, you can change the TV channels.
When you mm off the TV/DVD in the DVD mode,
when you turn it on again, it will return to the TV
mode.
This television has a degaussing circuit that will clear
up color errors on the TV screen that are caused by
any excess magnetism which happens to get too
close to the TV. This circuit is designed to operate
once when the set is first plugged in. If minor color
errors are seen in some locations on the screen,
please unplug the TV %r approximately 15 minutes.
When the TV is plugged back in, the degaussing cir-
cuit will operate once to clear them up. Repeat this
plocedure any time the TV screen is accidentally
magnetized, or when the TV is moved or relocated.
The TV/DVD's picture controls
BRIGHT, CON-
TRAST, COLOR, TINT and SHARPNESS
are
preset to factory specifications. Although they arc
usually the best, you may need to make some further
adjustments for your individual preference.
Make sure ...
* TV/DVD power must be turned on.
"J Seec:
_:' #.r.,..¢;_s:,/::'
Press PICTURE on the remote control.
2 So,eel letsvo
wa
> :_ ,_,
Press Arrox_ (_/'_) until desired control is displayed.
BRIGHT
CONTRAST
COLOR
TINT
[_RIGHT
SHARPNESS
{{_
Ad_stt/epc
_eco_st_e
Press Arrow (-_1 / _) to adjust to your desired level
within 5 seconds.
NOTE:
* At step [3], the picture adjustment display will dis-
appear fi:om the TV screen after about 5 seconds
unless you press any buttons, even though you may
not be finished. In this case, repeat fi:om step [1].
Arrow
Button
_'_
Arrow Button
to decrease
to increase
BRIGHT
brightness
brightness
to decrease
to increase
CONTRAST
COlltrast
conhast
COLOR
to pale
to brilliant
TINT
to pul?le
to green
SHAPNESS
to soft
to dear
* If there is a po_er
failure of any kind, the unit will
retain
its memm T of the setting you have selected.
15
EN
0C28
Advertisement
Table of Contents
